Vehicle Applications
→ Ford F-150 Double Cab
- 2015-2024 (Non-Amplified)
- 2015-2017 (Amplified)
→ Installation Time
Introduction
The following instructions will guide you through the installation process to replace the Speakers in the factory locations and add amplifiers and a subwoofer to your Ford.
TIP Before you begin, review these instructions thoroughly and ensure that all parts are present and tools are available.
WARNING Metra Electronics does not assume any responsibility for damage resulting from incorrect installation.
→ Parts List
Number | Component | Quantity |
1 | Vibe 1” Tweeters | 2 |
2 | Vibe 6 ½” Speakers | 2 |
3 | Vibe 6x9” Speakers | 2 |
4 | Subwoofer with Enclosure | 1 |
5 | Vibe 4-Channel Amplifier | 2 |
6 | F-150 Amp Board | 1 |
7 | Tweeter Adapter Plate (82-5605) | 1 |
8 | 6x9 Speaker Adapter Plate (82-5606) | 1 |
9 | Speaker Harness (72-5602) | 2 |
10 | Speaker Adapter Ring (IBSBF65) | 1 |
11 | Speaker Adapter Ring (IBSBF69) | 1 |
12 | Non-Amped Tweeter Harness (LD-VB-TWTDH) | 1 |
13 | DSP T-Harness (LD-VB-DSPFD2) | 1 |
14 | Toyota Extension Harness (LD-VB-TYEXT) | 1 |
15 | AXDSPX-FD2 (NEW) | 1 |
16 | AXDSP Output Harness (LD-AXDSP-OUT2) | 1 |
17 | Load Resistors (BULK AXXESS) | 2 |
18 | 6-Channel RCA Cable (V10r176) | 1 |
19 | 2-Channel RCA Cable (V8R17) | 1 |
→ Required Tools
- 7mm, 10mm, 18mm
- Phillips Driver
- T20 Torx
- Panel Tool
- Uni Bit (Step Bit)
- Wire Cutters
- Wire Strippers
- Wire Fishing Tool
A-Pillar Tweeters Installation
Follow the instructions below to install the A-Pillar Tweeters.
A-Pillar Removal
- Using a panel tool, remove the two (2) covers from the handle on the A-Pillar.
- Remove the two (2) 10mm bolts from the handle.
- With the bolts removed, pull the handle of the trim away from the A-Pillar.
- With a Phillips screwdriver, remove the two (2) screws securing the factory tweeter in place on the panel, and remove the factory tweeter.
Tweeter Installation
- Remove the cup mount from the back of the new Vibe tweeter.
- Insert the tweeter into the metal tweeter mount and press the tweeter into the mount until the teeth of the bracket rest in the groove of the tweeter.
- Cut the tweeter bracket after the first hole on either side.
